Welcome to the official website of China metal processing!

About us|Sitemap|Collection

Hotline: (+86)769-83811196
(+86)13827205356
Current location:Home > Products > CNC Lathe Parts >
prevnext

3 in 1 lathe process_lathe machine shop

Categories: Home
Product Introduction:lathe machine shop
Order Hotline:
3 in 1 lathe process_lathe machine shop
Machinery and equipment production and processing process,Safety is the most important.Cutting parts such as lathe should pay attention to the clamping method,This is very important for safety, take a look below ...

Precision machinery parts production and processing,The Clamping Method of Lathe Cutting

1, with a three-jaw chucking parts for roughing or finishing car cutting,If the workpiece diameter is less than or equal to 30mm,Its overhang length should not be greater than 5 times the diameter,If the workpiece diameter greater than 30mm,Its overhang length should not be greater than 3 times the diameter.

2, with four-jaw chuck, disk, angle iron (bending), such as clamping the irregular emphasis on the workpiece, you must add weight.

3, in the top of the shaft between the workpiece class,Before turning the tailstock to adjust the top center and lathe spindle center line coincidence.

4, in order to avoid injury has been processed surface,In the clamping, the surface should be processed,Pad with soft metal (copper. Aluminum) 5,In the incomplete part of the arc-shaped turning,In order to facilitate the measurement and maintain the balance,Should be two parts relative clamping,Single-piece production,The measuring block should be mounted opposite.

6, cylindrical thin-walled parts processing, the outer circle, in order to avoid clamping deformation,Axial clamping shall be used.

7, turning slender shaft,Prior to clamping fixture calibration,Rough bending when the wool is not more than 1 mm,Finished when the wool bending of not more than 0.2 mm.Turning the slender shaft using the turning tool,The main angle of 75 ° ~ 90 °,An angle of 15 ° to 25 °,And grinding a circle-shaped chip breaker,Keep the blade sharp,Allow sufficient cooling when turning.

8, between the two tops in the processing of slender shaft,Use a turret or center mount.In the processing process should pay attention to adjust the top of the top of the tight,Dead top and center frame should pay attention to lubrication.


lathe machine shop
 

* RequiredPurchase:3 in 1 lathe process_lathe machine shop
* Contacts: Please fill in your name
* Mobile phone: Please fill in your contact phone
* E-mail:
Description of purchase intention:
machining small metal parts shop
machining small metal parts shop
machining small metal parts shop
CNC lathe processing_Cylindrical Centerless gr
CNC lathe processing_Cylindrical Centerless gr
CNC lathe processing_Cylindrical Centerless gr
3 in 1 lathe process_lathe machine shop
3 in 1 lathe process_lathe machine shop
3 in 1 lathe process_lathe machine shop
Contact us

Tel:(+86)769-83811196

Fax:(+86)769-86831418

E-mail:87886663

Address:No. 51 Luming Road Heavy River Management District - Qing Town Dongguan City